Because vinyl fence columbus ohio systems use panels that lock into place, installing them is actually a snap.
Mark the Fence Location
Once you have determined the property line and lawful setback, mark out the Place of the fence. Mark the locations of the corner post holes with spray paint. Mark the locations of the remaining line posts, keeping the space between the posts evenly spaced at approximately 8'.
Temporarily Establish the Posts
Employing a pole digger, dig holes approximately 24" deep and 10" In diameter. Add a few inches of gravel into the bottom of the holes for drainage. Insert corner posts in holes. Make sure the articles are level and plumb.
Run a String Line
Run a string line in the top borders of the corner posts. Make sure the String is taut and level. This provides a guide to ensure that the articles are all installed at the same height. Install remaining line posts checking that each is plumb and in precisely the same height as the corner posts.
Build the Fence Panels
Vinyl fence panels are comprised in a base rail, top rail and slats. Collect them according to manufacturer's directions.
Permanently Set the Posts
Mix fast-drying cement according to manufacturer's instructions and pour in holes. Leave the two" x 4" bracing set up overnight while the cement Remedies. Remove the bracing. Apply PVC cement to the inside of the post caps and Then install atop posts.